WAY 5000 CREDIT CARD TERMINAL HOW TO
WAY 5000 CREDIT CARD TERMINAL INSTALL

When the terminal first powers on, you will see a welcome message on the terminal screen.When you first power on your terminal, simply respond to the prompts on screen to configure your terminal setup. The Move5000 terminal is a mobile payment terminal that connects to your local network with WiFi. Now that your terminal is on, you'll need to connect the terminal to your local WiFi network and configure a few important settings. Ĭonfigure terminal connection and settings If you are using the optional charging base, please refer to the charging instructions on Moneris' Move5000 setup guide. NOTE: The above instructions for powering your terminal are for a direct-to-terminal charging cable. Charge the terminal until the battery is full, as represented by a solid battery icon.If the terminal is charging, you'll notice a lightning symbol on the battery icon. Locate the Battery icon on the terminal's status bar, appearing on the top of the terminal screen.Wait for a welcome message to appear on screen (this will generally take a minute or two).Plug the pronged end of the power cable into a power outlet.Locate the power port on the left side of the terminal.Make sure you have your direct-to-terminal charging cable, the terminal and an accessible power outlet nearby.The paper should unroll over the back of the terminal, not over the faceplate. Close the lid, and press down to snap it back into place so that the extended paper is pressed securely against the closed lid and the faceplate.While doing so, make sure the paper roll stays taut and doesn't unravel. Insert a paper roll into the well with the paper pulling under and out towards the terminal.Lift the printer latch up, and then pull back to open the lid and expose the paper well.Once your hardware is connected, you'll connect your terminal to WiFi and adjust settings.

WAY 5000 CREDIT CARD TERMINAL INSTALL

Please note that Lightspeed Restaurant only supports the WiFi only model.įirst things first! Install a paper roll, then connect your terminal to power. Note: Moneris offers two types of Move5000 models: a WiFi only, and a 4G/WiFi model. Charging base and charging base power cable (optional).To order additional paper rolls, please contact Moneris. The following equipment is included in your hardware shipment when ordering through Lightspeed. Configure terminal connection and settingsīefore we get started, please make sure you have the proper hardware on hand.Follow the steps below to set up your terminal:

WAY 5000 CREDIT CARD TERMINAL HOW TO

This article explains how to set up your Moneris Desk5000 terminal, from hardware to software installation. Please note that your establishment must also have a Liteserver if using the Move5000 with Lightspeed Restaurant. Instead of prompting for payment from the POS screen, use the Move5000 to directly process payments where your customers are: meet your customers tableside and process transactions all from the terminal. The Move5000 is best suited for pay-at-table or mobile restaurant environments.

Since it is a mobile terminal, it connects to your network through a WiFi and Liteserver connection. The Ingenico Move5000 is a mobile terminal from Moneris.

Way 5000 credit card terminal